A broken garage door spring is one of the most common reasons a garage door stops working. When a spring snaps, the door becomes too heavy for the opener to lift and it will not move. Garage Door Wylie replaces torsion and extension springs for homeowners across Wylie, Murphy, Lavon, St. Paul, and Inspiration. We stock common spring sizes on every truck and aim to get your door working the same day you call.
What types of springs does Garage Door Wylie replace?
Most homes in Wylie and the surrounding suburbs use one of two spring systems.
- Torsion springs sit on a steel shaft above the door opening. They store energy by twisting as the door closes and release it when the door opens. A single-car door typically uses one torsion spring. A double-car door usually has two. Torsion systems are more common on heavier doors like Clopay Gallery and Reserve Wood Collection doors and Wayne Dalton Torquemaster systems.
- Extension springs run along the horizontal tracks on each side of the door. They stretch and contract with door movement. You see them often on lighter single-car doors and older setups. CHI and Amarr entry-level doors commonly ship with extension spring hardware.
We also replace EZ-Set and Torquemaster springs used on Wayne Dalton doors, which require specific tools that differ from standard torsion work. Whatever system your door uses, we bring the right hardware for the job.
How do you know if your spring is broken and what happens during the repair?
The signs are usually obvious. The door either will not open at all, opens a few inches and stops, or the opener motor runs but nothing moves. You may also see a visible gap in the spring coil above the door. In some cases you heard a loud bang inside the garage, which is the spring snapping under tension.
Here is what to expect when we arrive:
- We inspect the full spring system, cables, drums, and bottom brackets. A broken spring can put extra stress on cables and pulleys, so we check those too.
- We measure the door weight, wire diameter, inside diameter, and overall spring length to match the correct replacement spring.
- We release any remaining tension safely, remove the broken spring, and install the new spring with proper winding tension.
- We test door balance by hand before reconnecting your opener. A LiftMaster 8500W or Chamberlain B2405 should lift the door with minimal strain. If the door feels heavy after a spring replacement, balance is off and we adjust before we leave.
- We do a full cycle test with the opener and safety reversal check.
Standard replacement springs are rated around 10,000 cycles. High-cycle springs reach 25,000 to 50,000 cycles and are worth considering if your family runs the door many times a day, which is common in busy Wylie neighborhoods where kids are in and out after school.
Why call Garage Door Wylie for spring replacement instead of waiting or doing it yourself?
Spring replacement is one of the most dangerous DIY garage door repairs. A torsion spring under full tension holds serious stored energy. If a spring slips during winding, it can cause severe injury. This is not an area where watching a few videos and borrowing winding bars from a neighbor is a smart call.
Beyond safety, getting the spring size wrong leads to poor door balance. A door that is too heavy strains the opener motor. A Genie ChainMax 1000 or LiftMaster 3240 is not built to compensate for an under-tensioned spring night after night. Over time that shortens the life of your opener.
Garage Door Wylie is local. We are not a call center routing jobs to whoever is available. When you call us, you get a technician who works in Wylie, Murphy, Lavon, and St. Paul regularly and knows the common door models in these neighborhoods. We give you a straight answer on what broke, what it needs, and what your options are before any work starts.
Spring replacement cost depends on the spring type, the cycle rating you choose, and whether cables or other hardware need attention at the same time. We walk you through all of it so there are no surprises on the invoice.
If your garage door is not moving this morning, call Garage Door Wylie at (469) 491-7394. We will get a technician out to you fast and get your door back on track.
Frequently asked questions
How long does a spring replacement take?
Most spring replacements take about one to two hours from the time a technician arrives. We carry common spring sizes on the truck, so there is rarely a wait for parts.
Can I replace just one spring if only one broke?
We always recommend replacing both springs at the same time. If one spring failed, the other is usually near the end of its cycle life too. Replacing both saves you a second service call soon after.
Is a broken spring covered by a garage door warranty?
Spring warranties vary by manufacturer and the cycle rating of the spring installed. Standard springs are often rated for 10,000 cycles. High-cycle springs carry longer coverage. We explain exactly what warranty applies before we start any work.
Stuck door in Wylie? Your neighbors call us.
Call (469) 491-7394